Commercial Kitchens

Stonex Sand

Stonex Sand is a very fine quartz system combined with an epoxy binder resin, giving a very hard and tough surface. The surface is pore filled with an epoxy gel ensuring it remains non porous and stain resistant. A further polyurethane finishing coat is added with a non slip media to ensure the finished surface is slip resistant. Also widely used in heavy industrial area. Numerous colours available.


A stonex sand floor is comprised of millions grains of coloured sand that was processed for millions of years on river beds by erosion. This grains are coloured and sieved to produce a high quality, very fine aggregate.

The grains are then combined with an epoxy binding agent, trowelled into place before being pore filled with another epoxy and finally sealed with a polyurethane sealing coat.

The result is a very hard, wear resistant, seamless floor with infinite colour choices available.

Characteristic and benefits; hard wearing, colourful, non porous, chemical resistant, non slip (with additive)

Typical uses; Swimming pool surroundschanging roomscommercial kitchens, nightclub floors,





Quartz Sand

Photo 19-06-2015 15 24 17Fine quartz is cleaned, dried, coloured and sieved into size. There are different sieve sizes and combination of sieve sizes that give a unique finish to the floor.

Flexflooring source high quality quartz and can colour match or come up with unique coloured blends that will be bespoke to the individual or you can opt for some of our popular blends.


epoxyThe small granules of sand are combined with a low viscosity, colourless epoxy binder, mixed together before being trowelled into place. Epoxies are known to be very hard and resistant to various chemical and mechanical loadings.

Flexflooring source various different epoxies from around Europe.

Pore filling and sealing

Pore Fill

Once the Stonex sand floor has been laid and sufficiently cured (normally around 24 hours), the surface has to be pore filled with another epoxy substance, know as a thixotropic epoxy. This epoxy is forced into the surface filling all the microscopic pores that exist, making it a non porous surface. Normally two coats are applied to fill all the pores.

Once this has all cured, a final matt seal coat is normally applied. At this stage, an additive can be made to improve the non slip qualities of the surface, especially important in wet environments such as changing rooms.


Stonex Sand is 100% solids epoxy combined with a bespoke graded fine quartz. It provides a high build system that is impact resistant, can withstand chemical loading and is very durable. Otherwise known as an epoxy mortar.


Stonex sand can be used to create a hard wearing, seamless surface, and can be used in industrial or commercial environments, where traffic is heavy, and the floor is subject to heavy chemical loading.


Surfaces must be structurally sound, dry and degreased. The surface must be of sufficient texture to allow the material to key. New concrete surfaces must be allowed to cure for at least 28 days. Test for moisture content before installation.

Mechanically abrade the surface to obtain textured finish, grinding / shot blasting etc.

Crack filling, infill all cracks with a suitable epoxy and tape.


Prime the surface with a suitable epoxy primer and to improve the mechanical key further, broadcast sand into the primed surface.

Mix the Stonex Sand with the epoxy, with a binder ratio of 10%, apply to the surface with a metal float.

Once cured, use a squeegee, to force in a thixotropic epoxy gel to pore fill. Allow to cure and apply again.

Finishing coats

Once cured, apply a PU matt coat evenly with a roller.

Wet Leisure Blends

14284965 10209101213840788 757845623 o1
Coral Reef
Coral Reef
Pacific Stonex Sand1
14203585 10209101129078669 364307176 o
To make an enquiry fill out the form below or call us on 01622 747909

Enquiry Box

  • This field is for validation purposes and should be left unchanged.
Enquire Now